Solutions · Electronics production
Production test that runs the same every time
Consumer and industrial electronics need a functional test on every unit. m8rix turns your test procedure into a plan the whole line runs the same way, with a record for every serial number.
What you can validate
m8rix for electronics production
- Functional testPower-on, current draw per mode and output checks against limits, for every unit.
- Firmware programmingFlash the production image and read it back as part of the test.
- Calibration checksMeasurements against reference instruments, with the result stored per unit.
- A record for every unitPass or fail with the readings behind it, kept for traceability.
Workflows
Say what to test. It runs the rest.
Each workflow starts with a sentence. The agent turns it into a plan you review, then runs it on your bench.
01
End-of-line test
Flash, power up, check each rail and output, and mark the unit pass or fail.
> Run the end-of-line test on this board and record the serial number.
02
Current-draw check
Measure current in every operating mode and compare with the limits.
> Check current draw in sleep, idle and active modes against the limits.
03
New product test plan
Describe what to check; the agent drafts the plan, you review it, then it runs on the line.
> Draft a production test for the new sensor board from its test spec.
Why m8rix
Built for hardware that has to work
Limits it cannot cross
Your device's ratings are hard limits, checked on every step by deterministic code. The AI can't loosen them.
Every run on the record
Every command, who asked for it and the result, with the data and waveforms kept for review.
No test code to maintain
Change the procedure in plain English instead of rewriting test scripts.
On this bench
- Power supplies335
- Multimeters6
- Electronic loads11
- Oscilloscopes171
- Power analyzers and DAQ3
- and anything else with SCPI
Other solutions
See it run on your own bench
Free for Mac and Windows. Start on a simulated bench, then connect your instruments.