Solutions · Robotics

Bring up the electronics that make robots move

Motor drives, servo controllers, sensor boards and battery packs go through many revisions. m8rix gives each revision the same full test, with the firmware in the loop.

Book a demoDownload

What you can validate

m8rix for robotics

  • Motor drives and servo controllersPhase currents, switching waveforms and protection, into real motors or electronic loads.
  • Control-loop firmwareBuild and flash, step the command, measure the response, tune and repeat.
  • Sensor and encoder boardsSignal chains checked with signal generators across range and noise.
  • Battery packs and power distributionCharge, discharge and protection behaviour with battery simulators and loads.
01Tune the firmware02Step and measure03Check the response

Workflows

Say what to test. It runs the rest.

Each workflow starts with a sentence. The agent turns it into a plan you review, then runs it on your bench.

01

Step response

Command a step, capture the response on the scope, measure overshoot and settling.

> Step the servo from 0 to 90 degrees and measure overshoot and settling time.

02

Drive thermal soak

Hold the drive at load for hours, logging current, voltage and efficiency.

> Run the motor drive at 80 % load for four hours and log efficiency every minute.

03

Revision regression

The same checks on every board revision, compared side by side.

> Run the rev C board through the rev B test plan and compare.

Why m8rix

Built for hardware that has to work

Limits it cannot cross

Your device's ratings are hard limits, checked on every step by deterministic code. The AI can't loosen them.

Every run on the record

Every command, who asked for it and the result, with the data and waveforms kept for review.

Firmware in the loop

The agent can change the code, reflash and measure again until the result is in spec.

On this bench

  • Power supplies335
  • Electronic loads11
  • Oscilloscopes171
  • Signal generators97
  • Battery and PV simulators11
  • and anything else with SCPI

Other solutions

Space and satellitesPower, payload and flight boards, qualified before launchLaunch vehiclesAvionics, engine controllers and flight-computer HILEV and automotiveBMS, chargers, inverters and ECU firmwareDefenceRuggedised power and RF, tested to spec, on your own machinesResearch labsRepeatable experiments on shared benchesSemiconductorsSilicon bring-up and characterisation across cornersEnergySolar inverters, storage and PV simulationElectronics productionEnd-of-line and production test, run the same every time

See it run on your own bench

Free for Mac and Windows. Start on a simulated bench, then connect your instruments.

Download for MacDownload for Windows
Book a demo